Configure IP Network with ‘nmtui’ Tool

Network

An alternative for the nmcli is the nmtui, short for Network Manager Text User Interface, the nmtui is yet another handy tool that allows you to easily configure your network interfaces in Linux distributions using a graphical display by invoking the nmtui command straight from the terminal or even putty.

To configure a network interface IPv4 address, start by invoking the nmtui tool.

$ nmtui

Select the first option ‘Edit a connection’ and hit ENTER.

Edit Network Interface Connection

Edit Network Interface Connection

Next, select the interface you want to configure and hit ENTER. In this case, the interface we are configuring is enps03.

Select Network Interface

Select Network Interface

 

In the next step, key in the preferred IP address and define the subnet mask, default gateway, and DNS servers as shown below.

Configure Network Connection

Configure Network Connection

Once you are satisfied with your settings, scroll all the way down and hit ENTER on the ‘OK’ option.

Confirm Network Settings

Confirm Network Settings

This takes you back to the interfaces screen as shown below. Navigate and hit on the ‘Back’ option.

Network Interface Settings

Network Interface Settings

Select ‘Activate a connection’ and then ‘OK’ and hit ENTER.

Active Network Connection

Active Network Connection

Select your interface name and then navigate to the ‘Deactivate’ option and hit ENTER.

Deactivate Network Connection

Deactivate Network Connection

This will take you a step back whereupon you will click on the ‘Activate’ option as shown:

Active Network Connection

Active Network Connection

We’re all done now. To go back click on the ‘Back’ option and finally, press ENTER on the ‘quit’ selection.

Quit Network Configuration

Quit Network Configuration

Again, to verify that the network interface has acquired the IP address we have just configured, run the command:

$ ip addr show enp0s3

Confirm Network IP Address

Confirm Network IP Address

And this concludes this article on configuring IP network connection using ‘nmtui’ graphical command-line utility on Linux. We hope you found this guide helpful.

Source

Share: